Quick Start

If you are using a |SS200| or SN220 SNAPstick, SNAPtoolbelt can scan for your node(s):

$ snap config scan

SNAPtoolbelt will automagically add new nodes (including sniffer nodes) to your configuration.

Note

If you get a message about a Read error, you can bypass it by adding the -f/--force flag. Read errors may just mean (a) this node’s actually a SNAP Sniffer, we were looking for non-Sniffer nodes, or (b) it was busy when we tried to talk to it.

To make one of them your default, move it to the default profile:

$ snap config move profile SNAPstick0 default